文献类型：期刊文献

英文题名：Experimental study on peeling performance of T-type brazing joints

作者：Duan, Peng-Yang[1];Wang, Dong-Xing[1];Zhou, Guo-Yan[1];Tu, Shan-Tung[1]

机构：[1]East China Univ Sci & Technol, Sch Mech & Power Engn, Key Lab Pressure Syst & Safety MOE, Shanghai 200237, Peoples R China

年份：2019

卷号：172

起止页码：70

外文期刊名：INTERNATIONAL JOURNAL OF PRESSURE VESSELS AND PIPING

收录：;EI(收录号：20191206671610);WOS:【SCI-EXPANDED(收录号:WOS:000470052600009)】；

基金：The work was supported by National Natural Science Foundation of China (No. 51675181).

语种：英文

外文关键词：Brazing joint; T-type peel test; Plate-fin structure; High temperature

摘要：As a promising heat transfer component of high temperature gas cooled reactor (HTGR), the performance of the plate-fin heat exchanger determines the energy efficiency and life of the HTGR. Although the plate-fin structure has lots of advantages such as high efficiency, compact structure, low manufacturing cost, its performance is greatly affected by the vacuum brazing technology and harsh conditions, e.g. high temperature and high pressure. In the practical application, "peeling" failures may occur in the brazing joint between the fin and the parting sheet. It becomes necessary to characterize the strength of the joints. However, the standard specimen cannot accurately describe the real stress distribution. In the present study, a T-type specimen is designed for the peel test of brazing joints. To reflect the influence of brazing seams and thickness of the base metal, five specimens are designed and tested under 25 degrees C, 450 degrees C, 550 degrees C and 650 degrees C with five different applied loads, respectively. Based on the bilinear hardening model, the peeling performance of all T-type joints are obtained according to the tested peeling force-displacement curves. Then the influences of base metal thickness, brazing seam, loading rate and test temperature on the peeling performance are analyzed. The results show that the maximum peel force, the average peeling force and the fracture energy all decrease as the results of increased base metal thickness. With the increase of the filler thickness, the average peeling force and the fracture energy of the brazing joints both decrease. The joints with 0.95 mm base metal thickness and two layers of brazing filler metal are recommended for the peeling test of the T-type specimen. The loading rate of the peel test has no significant effect on the average peeling force and the fracture energy.