文献类型：期刊文献

中文题名：基于山梨醇类α成核剂的α/β复合成核剂对等规聚丙烯力学性能的影响

英文题名：Effects of α/β Composite Nucleating Agents Based on Sobitol α Nucleating Agents on Mechanical Properties of Isotactic Polypropylene

作者：石尧麒[1];辛忠[1];赵世成[1]

机构：[1]华东理工大学化工学院产品工程系化学工程联合国家重点实验室,上海200237

年份：2013

卷号：42

期号：10

起止页码：1097

中文期刊名：石油化工

外文期刊名：Petrochemical Technology

收录：CSTPCD;;Scopus;北大核心:【北大核心2011】；CSCD:【CSCD_E2013_2014】；

基金：国家自然科学基金资助项目(U1162110;21106042;21306047);中央高校基础研究基金(WA1314051;WA1013012);上海市优秀学科带头人计划项目(XD1401500)

语种：中文

中文关键词：等规聚丙烯;山梨醇类成核剂;α/β复合成核剂

外文关键词：isotactic polypropylene; sobitol nucleating agent; a／β composite nucleating agent

摘要：以山梨醇类成核剂S20为α成核剂分别与3种β成核剂TMB-5,HHPA-Ba,PA-03复合得到复合成核剂,建立了成核剂含量与ΔTCp(ΔTCp为成核等规聚丙烯(iPP)结晶峰值温度与非成核iPP结晶峰值温度的差值)的关系曲线,考察了复合成核剂对iPP力学性能的影响。实验结果表明,通过成核剂含量与ΔTCp的关系曲线可确定复合成核剂的最佳配比;以S20为α成核剂制备复合成核剂时,复合成核剂的总含量以大于0.10%(w)(基于iPP的质量)为宜;确立复合成核剂最佳配比的实验方法适用于以S20为α成核剂的α/β复合成核剂体系;当成核剂以最佳配比复合时,成核iPP的刚性和韧性可同时提高。
The effects of three a/β composite nucleating agents（NAs）, including S20/TMB-5, S20/HHPA-Ba and S20/PA-03, on the mechanical properties of isotactic polypropylene（iPP） were investigated. To determine the optimal ratio of the a/β NAs, a method based on the relationships between the NA contents and ATcp （the difference between crystallization peak temperatures of nucleated and non-nucleated iPP） were established. The results showed that when S20 was used as a/β NA, the appropriate dosage of the a/β composite NAs should be higher than 0.10% （w）. The proposed method was suitable for any kinds of a/J3 composite NAs based on S20 as the u NA. With an optimized ratio, a/β composite NAs can improve both the rigidity and toughness of nucleated iPE