文献类型：期刊文献

中文题名：Ti-6Al-4V钛合金长寿命疲劳试验

英文题名：High cycle fatigue in Ti-6Al-4V titanium alloy

作者：赖焕生[1];李煜佳[1];轩福贞[1];涂善东[1]

机构：[1]华东理工大学机械与动力工程学院,上海200237

年份：2009

卷号：31

期号：5

起止页码：15

中文期刊名：南京工业大学学报（自然科学版）

外文期刊名：Journal of Nanjing Tech University(Natural Science Edition)

收录：CSTPCD;;北大核心:【北大核心2008】；

基金：国家自然科学基金资助项目(20576055)

语种：中文

中文关键词：Ti-6Al-4V钛合金;Goodman曲线;高周疲劳强度

外文关键词：Ti-6Al-4V titanium alloy; Goodman diagram; high cycle fatigue strength;

摘要：研究了Ti-6Al-4V在室温空气环境下的疲劳性能,获得疲劳寿命为107下的Goodman曲线.结果表明,用简化的Goodman直线代替Goodman曲线对于Ti-6Al-4V钛合金偏于保守.对断口形貌的观察表明应力比R在0附近时裂纹萌生于内部,而当应力比接近-1和1时裂纹萌生于表面.另外,研究了估算Ti-6Al-4V在不同应力比的疲劳强度估算公式,得出Ti-6Al-4V厚板和挤压件缺口试样估算公式的系数,分别为1.422和1.042.
Fatigue tests were conducted in Ti-6Al-4V at air atmosphere and room temperature. Goodman diagram of Ti-6Al-4V was acquired in high-cycle of 107. The result shows that Goodman straight line of Ti-6Al-4V titanium alloy is more conservative than Goodman curve. The fracture surfaces of the fatigued specimen showed that fatigue cracks almost initiate from material inside by the stress ratio R around 0, while on the surface by R around - 1 or 1. The formula for estimating fatigue strength of Ti-6Al-4V at different stress ratios was proposed, also. Results reveal that the estimating formula coefficients for thick plant and compresion specimens with notch of Ti-6Al-4V are 1. 422 and 1. 042.