文献类型：期刊文献

中文题名：PP/EOR合金的可控膨胀及光(热)致变形研究

英文题名：CONTROLLED EXPANSION AND LIGHT(HEAT)-INDUCED DEFORMATION OF PP/EOR ALLOYS

作者：江建第[1];徐海波[1];李宇岩[1];张栋葛[1];吴国章[1]

机构：[1]华东理工大学材料科学与工程学院,上海200237

年份：2010

卷号：38

期号：5

起止页码：6

中文期刊名：工程塑料应用

外文期刊名：Engineering Plastics Application

收录：CSTPCD;;北大核心:【北大核心2008】；CSCD:【CSCD2011_2012】；

基金：国家自然科学基金项目(50873033);国家大学生创新实验计划(081025103)

语种：中文

中文关键词：聚丙烯;(乙烯/辛烯)共聚物;合金;低膨胀;光(热)致变形

外文关键词：PP, EOR, alloy, low thermal expansion, light（ heat） -induced deformation

摘要：通过在聚丙烯(PP)基体中填充(乙烯/辛烯)共聚物(EOR),采用调控粘度比和改变成型加工方法制备了相同组分下线性热膨胀系数(CLTE)各异的PP/EOR合金,利用注射成型工艺将两种CLTE差异极大的材料粘结在一起。研究结果表明,随着橡胶相的加入,模压PP/EOR体系的CLTE较PP明显升高,但注塑PP/EOR体系的CLTE则显著降低;SEM分析表明注塑PP/EOR体系形成了层状共连续结构;复合体有很高的光致变形效果,变形率最大达28%。
PP/EOR alloys with different coefficient of linear thermal expansion （CLTE） under same constitution were prepared by choosing appropriate viscosity ratio and processing methods. The results showed that the CLTE of press - molded PP/EOR alloy was significantly elevated by the addition of EOR; however, the CLTE of injection molded counterparts were greatly reduced, the minimum to 4.37×10 -^-5 PC. SEM observation showed that the phase structure of injection-molded PP/EOR alloy was micro-layer cocontinuous. With the decrease of viscosity ratio, the CLTE of injection systems could be further reduced. The two types of materials with greatly different CLTE were firmly bonded by the injection molding process. The complex responded rapidly when given light contact for only 10s, and eventually reached stability when the sample achieved the deformation rate of 28%.