文献类型：期刊文献

中文题名：PEO/CaCO_3/PLA复合材料开孔结构的制备

英文题名：Preparation of Open Cell Porous Material by Leaching PEO/CaCO_3/PLA Composite Material

作者：王云祥[1];谢林生[1];马玉录[1];张颖[1];郝玉婷[1]

机构：[1]华东理工大学绿色高效过程装备与节能教育部工程研究中心,上海200237

年份：2016

卷号：32

期号：12

起止页码：121

中文期刊名：高分子材料科学与工程

外文期刊名：Polymer Materials Science & Engineering

收录：CSTPCD;;EI(收录号：20165203194736);Scopus;北大核心:【北大核心2014】；CSCD:【CSCD2015_2016】；

基金：国家自然科学基金资助项目(51273065)

语种：中文

中文关键词：聚乳酸;碳酸钙;聚氧化乙烯;多孔材料;连续混炼机

外文关键词：polylactic acid; calcium carbonate; polyethylene oxide; porous materials; continuous mixer

摘要：采用聚乳酸(PLA)、聚氧化乙烯(PEO)、碳酸钙(CaCO_3)熔融共混制备具有开孔结构的PLA多孔材料,借助于扫描电镜、孔隙率、热分析和压缩性能的测试方法,研究了连续混炼工艺对多孔材料结构和性能的影响。结果表明,过高或过低的转子转速和加料量都会导致多孔材料孔隙率的下降。当转子转速为600 r/min,加料量为2.61 kg/h时,孔隙率达到最大值76.8%,压缩模量和压缩强度分别为4.3 MPa和2.9 MPa。提高转子转速有利于多孔材料结晶性能的提高。
Using polylactic acid （PLA）/polyethylene oxide （PEO）/CaCO3, PLA porous materials with open cell were prepared by blending method. Series characterizations such as SEM, DSC, porosity and compressive property were conducted to study the effect of continuous mixing process on morphologies and properties of the porous material. The results indicate that too high or too low rotor speed and feed speed will result in decrease of the porosity. The porosity of the porous material reaches to the maximum of 76.8% when the rotor speed is 600 r/min and the feed speed is 2.61 kg/h, and the compressive modulus and compressive strength is 4.3 MPa and 2.9 MPa respectively. The improvement of rotor speed will be beneficial to improvement of the crystallization property of porous materials.