文献类型：期刊文献

英文题名：Influence of Ultrasonic Surface Rolling Process and Shot Peening on Fretting Fatigue Performance of Ti-6Al-4V

作者：Wang, Ning[1];Zhu, Jinlong[1];Liu, Bai[1];Zhang, Xiancheng[1];Zhang, Jiamin[1];Tu, Shantung[1]

机构：[1]East China Univ Sci & Technol, Key Lab Pressurized Syst & Safety, Shanghai 200237, Peoples R China

年份：2021

卷号：34

期号：1

外文期刊名：CHINESE JOURNAL OF MECHANICAL ENGINEERING

收录：;EI(收录号：20220216581);WOS:【SCI-EXPANDED(收录号:WOS:000697181400002)】；

基金：Supported by National Key Research and Development Project (Grant No.2018YFC1902400) and Natural Science Foundation of Shanghai (Grant No. 20ZR1415300).

语种：英文

外文关键词：Ti-6Al-4V; Fretting fatigue; Residual stress; Ultrasonic surface rolling process; Surface strengthening

摘要：At present, there are many studies on the residual stress field and plastic strain field introduced by surface strengthening, which can well hinder the initiation of early fatigue cracks and delay the propagation of fatigue cracks. However, there are few studies on the effects of these key factors on fretting wear. In the paper, shot-peening (SP) and ultrasonic surface rolling process (USRP) were performed on Ti-6Al-4V plate specimens. The surface hardness and residual stresses of the material were tested by vickers indenter and X-ray diffraction residual stress analyzer. Microhardness were measured by HXD-1000MC/CD micro Vickers hardness tester. The effects of different surface strengthening on its fretting fatigue properties were verified by fretting fatigue experiments. The fretting fatigue fracture surface and wear morphology of the specimens were studied and analyzed by means of microscopic observation, and the mechanism of improving fretting fatigue life by surface strengthening process was further explained. After USRP treatment, the surface roughness of Ti-6Al-4V is significantly improved. In addition, the microhardness of the specimen after SP reaches the maximum at 80 mu m from the surface, which is about 123% higher than that of the AsR specimen. After USRP, it reaches the maximum at 150 mu m from the surface, which is about 128% higher than that of AsR specimen. It is also found that the residual compressive stress of the specimens treated by USRP and SP increases first and then decreases with the depth direction, and the residual stress reaches the maximum on the sub surface. The USRP specimen reaches the maximum value at 0.18 mm, about - 550 MPa, while the SP specimen reaches the maximum value at 0.1 mm, about - 380 MPa. The fretting fatigue life of Ti-6Al-4V effectively improved after USRP and SP. The surface integrity of specimens after USRP is the best, which has deeper residual compressive stress layer and more refined grain. In this paper, a fretting wear device is designed to carry out fretting fatigue experiments on specimens with different surface strengthening.