文献类型：期刊文献

中文题名：催化剂可循环使用的CWPO工艺处理高盐废水

英文题名：Treatment of high salinity wastewater using catalyst recyclable CWPO process

作者：韩跃飞[1];蔡宇[1];盛梅[1];杨林燕[1];曹国民[1]

机构：[1]华东理工大学环境工程研究所

年份：2019

卷号：39

期号：7

起止页码：77

中文期刊名：工业水处理

外文期刊名：Industrial Water Treatment

收录：CSTPCD;;北大核心:【北大核心2017】；CSCD:【CSCD_E2019_2020】；

语种：中文

中文关键词：催化湿式过氧化物氧化;催化剂;高盐有机废水;氯化钠;隔膜电解

外文关键词：catalytic wet peroxide oxidation(CWPO);catalyst;organic wastewater with high salinity;sodium chloride;diaphragm electrolysis

摘要：研究了Cu(Ⅱ)为催化剂的催化湿式过氧化物氧化法(CWPO)处理高盐环氧树脂废水的技术。结果表明,适宜反应条件为:pH=5.0,温度90 ℃,催化剂(CuSO4·5H2O)质量浓度3.0 g/L,氧化剂(30%H2O2)用量150 mL/L。在优化条件下,初始TOC为5 260 mg/L的高盐环氧树脂废水,经CWPO法处理后的TOC约为100 mg/L,可作为隔膜法生产氯碱的原料。到目前为止,该技术工程化应用已经1 a多,未排放过废催化剂(即催化剂全部循环使用)。
The technology for treating the high salinity epoxy resin wastewater by catalytic wet peroxide oxidation (CWPO) process with Cu(Ⅱ) as catalyst was studied. The results showed that the suitable reaction conditions consisted of pH,temperature,catalyst(CuSO4·5H2O) dosage,and oxidant(30% H2O2) dosage were 5.0,90 ℃,3.0 g/L,and 150 mL/L,respectively. Under optimal conditions,the TOC of high salinity epoxy resin wastewater would be degraded from 5 260 mg/L to about 100 mg/L. The treated epoxy resin wastewater could be reused as a raw material for producing chlorine gas and caustic soda by diaphragm method. So far,this technology has been applied in engineering for more than one year,and no waste catalyst has been discharged (that was,all the catalysts were recycled).